ADG founder Greg Dennison goes through the process of creating a custom program and saving it on the ARC Ultimate cartridge case annealer. The ARC ultimate controls the annealing by utilizing three variables – the height setting, the MHT temperature setting, and the MHT sensor selection. Basic operation begins with setting the height of the cartridge case within the induction core. This can be controlled by measuring the length from the base of the shell to the neck-shoulder junction in mm. This length can be directly put into the ARC Ultimate to set the initial height setting, centered in the middle of the induction core. The ARC Ultimate uses a 20mm diameter induction core and 5 MHT sensors spaced approximately 5mm apart. Sensor 2 is at the center of the induction core with sensor 1 about 5mm above it and the remaining sensors 3, 4, and 5 located at about 5mm increments below. Best results are typically obtained by first processing clean brass in order to facilitate a clean color line on the brass to give an indication of the depth of the anneal down the case body.